Skip to content

Next Gen STEP AP242 Native-ish BREP Geometric Modeling Kernel

1.0 KB
Raw Blame
Units: mm
Template < H: Length > Struct Pin {
    Circle2 Circle { center: [0mm,0mm] radius: 1mm }
    Profile Section { Loop Outer { Circle |> TraceLoop } }
    Extrude Body { profile: Section from: 0mm to: H }
}
Subassembly Inner {
    <Assembly Inner>
        <Part Origin = Pin<H: 1mm>></Part>
        <Part Tip = Pin<H: 4mm>>
            Placement ImportedOccurrence = [1,0,0,0, 0,1,0,0, 0,0,1,0, 5,7,11,1];
        </Part>
    </Assembly>
    anchor: Inner.Origin;
}
Subassembly Middle {
    <Assembly Middle>
        <Part Origin = Pin<H: 1mm>></Part>
        <Assembly Offset = Inner>
            Placement ImportedOccurrence = [1,0,0,0, 0,1,0,0, 0,0,1,0, 30,0,40,1];
        </Assembly>
    </Assembly>
    anchor: Middle.Origin;
}
Assembly NestedFrames {
    <Assembly NestedFrames>
        <Part Origin = Pin<H: 1mm>></Part>
        <Assembly Rotated = Middle>
            Placement ImportedOccurrence = [0,1,0,0, -1,0,0,0, 0,0,1,0, 100,200,300,1];
        </Assembly>
    </Assembly>
    anchor: NestedFrames.Origin;
}