Skip to content

Next Gen STEP AP242 Native-ish BREP Geometric Modeling Kernel

2.2 KB
Raw Blame
// Dimensional arguments are supplied by the typed design author.
// These ordinary templates are also usable without the demo executable.
Template < Rout: Length, Rin: Length, Zlow: Length, Zhigh: Length >
Struct Annulus {
    Circle2 Outside { Center: [0mm,0mm] Radius: Rout }
    Circle2 Inside { Center: [0mm,0mm] Radius: Rin }
    Profile Section { Loop Outer { Outside |> TraceLoop } Loop Inner { Inside As InnerBoundary |> TraceLoop } }
    Extrude Body { Profile: Section From: Zlow To: Zhigh }
}

Template < R: Length, Zlow: Length, Zhigh: Length >
Struct RoundBar {
    Circle2 Outside { Center: [0mm,0mm] Radius: R }
    Profile Section { Loop Outer { Outside |> TraceLoop } }
    Extrude Body { Profile: Section From: Zlow To: Zhigh }
}

Template < Rout: Length, Rin: Length, PitchR: Length, HoleD: Length, Zlow: Length, Zhigh: Length >
Struct DecimalIndexPlate {
    Circle2 Outside { Center: [0mm,0mm] Radius: Rout }
    Circle2 Inside { Center: [0mm,0mm] Radius: Rin }
    Profile Section { Loop Outer { Outside |> TraceLoop } Loop Inner { Inside As InnerBoundary |> TraceLoop } }
    Axis IndexAxis { Origin: [0mm,0mm,0mm]; Direction: [0,0,1] }
    Compose Body {
        Base Stock { Profile: Section From: Zlow To: Zhigh Role: Stock }
        Hole<Shaft> IndexZero { On: +Z Center: Point2(PitchR,0mm) Diameter: HoleD End: ThroughAll }
        Radial Pattern IndexPositions { Source: IndexZero About: IndexAxis Count: 10 Angle: full }
    }
}

Template < W: Length, D: Length, H: Length, ShaftD: Length, PinX: Length, PinD: Length, MountX: Length, MountY: Length >
Struct StorageSupport {
    Rect2 Outside { Center: [0mm,0mm] Size: [W,D] }
    Profile Section { Loop Outer { Outside |> TraceLoop } }
    Compose Body {
        Base Stock { Profile: Section From: 0mm To: H Role: Stock }
        Hole<Shaft> ShaftBore { On: +Z Center: Point2(0mm,0mm) Diameter: ShaftD End: ThroughAll }
        Hole<Shaft> PlungerGuide { On: +Z Center: Point2(PinX,0mm) Diameter: PinD End: ThroughAll }
        Hole<Shaft> MountLeft { On: +Z Center: Point2(-MountX,MountY) Diameter: 4.5mm End: ThroughAll }
        Hole<Shaft> MountRight { On: +Z Center: Point2(MountX,MountY) Diameter: 4.5mm End: ThroughAll }
    }
}