Skip to content

Next Gen STEP AP242 Native-ish BREP Geometric Modeling Kernel

1.9 KB
Raw Blame
Model ProfileComposeLBracketCounterborePmi {
    units: mm

    Record MountSpec { Center: Point2 Diameter: Length }
    Static Mounts: MountSpec[] = [
        MountSpec { Center: Point2(20mm, -10mm) Diameter: 6mm }
        MountSpec { Center: Point2(-30mm, 20mm) Diameter: 6mm }
    ]
    Template<spec: MountSpec> ShaftHole {
        Hole<Shaft> Mount {
            on: +Z
            center: spec.Center
            diameter: spec.Diameter
            end: ThroughAll
        }
    }

    Concept Struct Layout on XY {
        Rect2 Horizontal { center: [0mm, -10mm]; size: [80mm, 20mm] }
        Rect2 Vertical { center: [-30mm, 10mm]; size: [20mm, 60mm] }
        Point2 Notch { position: [-20mm, 0mm] }
    }

    Profile Bracket using Layout { Loop Outer {
        Horizontal.Bottom as South
            |> Horizontal.Right as East
            |> Horizontal.Top to Notch as Inner
            |> Vertical.Right to Vertical.TopRight as Upright
            |> Vertical.Top as North
            |> Vertical.Left to Horizontal.BottomLeft as West
            |> Close
    } }

    Struct BracketBody {
        Compose BracketBody {
            Base Stock { profile: Bracket; from: 0mm; to: 12mm; role: Stock }
            Pattern MountPattern over Mounts { ShaftHole<Current> }
            Hole<Counterbore> CounterboredMount {
                on: +Z
                center: Point2(-30mm, -10mm)
                diameter: 8mm
                counterboreDiameter: 14mm
                counterboreDepth: 4mm
                end: ThroughAll
            }
        }
    }

    Modify BracketBody {
        EdgeFinish TopPerimeter {
            Target: Bracket.Outer
            On: Top
            Kind: Chamfer
            Distance: 1mm
        }
    }

    Pmi {
        Datum A { Target: face(+Z) }
        HoleDiameter CounterboredMountDiameter {
            Target: CounterboredMount
            Value: 8mm
            Tolerance: PlusMinus(0.05mm, 0.02mm)
        }
    }
}