Skip to content

Next Gen STEP AP242 Native-ish BREP Geometric Modeling Kernel

1.0 KB
Raw Blame
Model RectanglePlate {
  units: mm
  Static outerCenterX: Length = 0mm
  Static outerCenterY: Length = 0mm
  Static outerWidth: Length = 80mm
  Static outerHeight: Length = 40mm
  Static wall: Length = 10mm
  Concept Struct layout on XY {
    Rect2 outer {
      center: [outerCenterX, outerCenterY]
      size: [outerWidth, outerHeight]
    }
    Rect2 notch {
      center: [outerCenterX + wall / 2, outerCenterY + wall / 2]
      size: [outerWidth - wall, outerHeight - wall]
    }
  }
  Profile section using layout {
    Loop Outer {
      outer.Bottom from outer.BottomLeft to outer.BottomRight as bottom
      |> outer.Right from outer.BottomRight to notch.BottomRight as right
      |> notch.Bottom from notch.BottomRight to notch.BottomLeft as ledge
      |> notch.Left from notch.BottomLeft to notch.TopLeft as upright
      |> outer.Top from notch.TopLeft to outer.TopLeft as top
      |> outer.Left from outer.TopLeft to outer.BottomLeft as left
      |> Close
    }
  }
  Extrude body { profile: section; from: 0mm; to: 6mm }
}