Skip to content

armgit / flix

Public Imported from GitHub
0

Making an ESP32-based quadcopter from scratch

1.7 KB
Raw Blame

Brief assembly guide

Soldered components (schematics variant):


Use double-sided tape to attach ESP32 to the top frame part (ESP32 holder):


Use two washers to screw the IMU board to the frame:


Screw the IMU with M3x5 screws as shown:


Install the motors, attach MOSFETs to the frame using tape:


Screw the ESP32 holder with M1.4x5 screws to the frame:


Assembled drone:

See an alternative assembly process photos here: https://drive.google.com/drive/folders/1FG5BH9RCzdf1XmJcC70PymiRMXcz6Fx7?usp=sharing.

Motor directions

[!WARNING] The drone above is an early build, and it has inversed motor directions scheme. The photos only illustrate the assembly process in general.

Use standard motor directions scheme:

Motors connection table:

Motor Position Direction Prop type Motor wires GPIO
Motor 0 Rear left Counter-clockwise B Black & White GPIO12 (TDI)
Motor 1 Rear right Clockwise A Blue & Red GPIO13 (TCK)
Motor 2 Front right Counter-clockwise B Black & White GPIO14 (TMS)
Motor 3 Front left Clockwise A Blue & Red GPIO15 (TD0)

Motors tightening

Motors should be installed very tightly — any vibration may lead to bad attitude estimation and unstable flight. If motors are loose, use tiny tape pieces to fix them tightly as shown below: