Skip to content

armgit / flix

Public Imported from GitHub
0

Making an ESP32-based quadcopter from scratch

Fixes to troubleshooting

Oleg Kalachev08b6123eb795
diff --git a/docs/troubleshooting.md b/docs/troubleshooting.md
index 7e48c93..509fd11 100644
--- a/docs/troubleshooting.md
+++ b/docs/troubleshooting.md
@@ -32,6 +32,6 @@ Do the following:
* `mfl` — should rotate front left motor (clockwise).
* `mrl` — should rotate rear left motor (counter-clockwise).
* `mrr` — should rotate rear right motor (clockwise).
-* **Calibrate the RC** if you use it. Type `cr` command in Serial Monitor and follow the instructions.
-* **Check the RC data** if you use it. Use `rc` command, `Control` should show correct values between -1 and 1, and between 0 and 1 for the throttle.
+* **Check the remote control**. Using `rc` command, check the control values reflect your sticks movement. All the controls should change between -1 and 1, and throttle between 0 and 1.
+* If using SBUS receiver, **calibrate the RC**. Type `cr` command in Serial Monitor and follow the instructions.
* **Check the IMU output using QGroundControl**. Connect to the drone using QGroundControl on your computer. Go to the *Analyze* tab, *MAVLINK Inspector*. Plot the data from the `SCALED_IMU` message. The gyroscope and accelerometer data should change according to the drone movement.