Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Minor doc fixes
Oleg Kalachev6c46328da1dd
diff --git a/docs/troubleshooting.md b/docs/troubleshooting.mdindex 2b2554d..94ce53c 100644--- a/docs/troubleshooting.md+++ b/docs/troubleshooting.md@@ -4,7 +4,7 @@Do the following:-* **Check ESP32 core is installed**. Check if the version matches the one used in the [tutorial](usage.md#firmware).+* **Check ESP32 core is installed**. Check if the version matches the one used in the [tutorial](usage.md#building-the-firmware).* **Check libraries**. Install all the required libraries from the tutorial. Make sure there are no MPU9250 or other peripherals libraries that may conflict with the ones used in the tutorial.* **Check the chosen board**. The correct board to choose in Arduino IDE for ESP32 Mini is *WEMOS D1 MINI ESP32*.@@ -25,7 +25,7 @@ Do the following:* The `accel` and `gyro` fields should change as you move the drone.* **Calibrate the accelerometer.** if is wasn't done before. Type `ca` command in Serial Monitor and follow the instructions.* **Check the attitude estimation**. Connect to the drone using QGroundControl. Rotate the drone in different orientations and check if the attitude estimation shown in QGroundControl is correct.-* **Check the IMU orientation is set correctly**. If the attitude estimation is rotated, make sure `rotateIMU` function is defined correctly in `imu.ino` file.+* **Check the IMU orientation is set correctly**. If the attitude estimation is rotated, set the correct IMU orientation as described in the [tutorial](usage.md#define-imu-orientation).* **Check the motors type**. Motors with exact 3.7V voltage are needed, not ranged working voltage (3.7V — 6V).* **Check the motors**. Perform the following commands using Serial Monitor:* `mfr` — should rotate front right motor (counter-clockwise).