Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Some docs improvements
Oleg Kalachev72a72fde8092
diff --git a/docs/usage.md b/docs/usage.mdindex 631ac82..39f9da4 100644--- a/docs/usage.md+++ b/docs/usage.md@@ -138,7 +138,7 @@ Before flight you need to calibrate the accelerometer:If using non-default motor pins, set the pin numbers using the parameters: `MOTOR_PIN_FL`, `MOTOR_PIN_FR`, `MOTOR_PIN_RL`, `MOTOR_PIN_RR` (front-left, front-right, rear-left, rear-right respectively).-Certain ESP32 models (such as ESP32-S3) support a lower maximum PWM frequency; on these boards the parameter `MOT_PWM_FREQ` should be set to 38000 Hz.+Certain ESP32 models (such as ESP32-S3 and ESP32-C3) support a lower maximum PWM frequency; on these boards the parameter `MOT_PWM_FREQ` should be set to 38000 Hz.If using brushless motors and ESCs:@@ -216,7 +216,7 @@ There are several ways to control the drone's flight: using **smartphone** (Wi-F### Control with a remote control-Before using SBUS-connected remote control you need to enable SBUS and calibrate it:+If using SBUS-connected remote control you need to enable SBUS and calibrate it:1. Connect to the drone using QGroundControl.2. In parameters, set the `RC_RX_PIN` parameter to the GPIO pin number where the SBUS signal is connected, for example: 4. Negative value disables SBUS.