Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Minor docs change
Oleg Kalachev814427dbfdcb
diff --git a/docs/troubleshooting.md b/docs/troubleshooting.mdindex 1d5293e..9b5925a 100644--- a/docs/troubleshooting.md+++ b/docs/troubleshooting.md@@ -13,7 +13,7 @@ Do the following:Do the following:* **Check the battery voltage**. Use a multimeter to measure the battery voltage. It should be in range of 3.7-4.2 V.-* **Check if there are some startup errors**. Connect the ESP32 to the computer and check the Serial Monitor output. Use the Reset button to make sure you see the whole ESP32 startup output.+* **Check if there are some startup errors**. Connect the ESP32 to the computer and check the Serial Monitor output. Use the Reset button or `reboot` command to see the whole startup output.* **Check the baudrate is correct**. If you see garbage characters in the Serial Monitor, make sure the baudrate is set to 115200.* **Make sure correct IMU model is chosen**. If using ICM-20948/MPU-6050 board, change `MPU9250` to `ICM20948`/`MPU6050` in the `imu.ino` file.* **Check if the console is working**. Perform `help` command in Serial Monitor. You should see the list of available commands. You can also access the console using QGroundControl *(Vehicle Setup* ⇒ *Analyze Tools* ⇒ *MAVLink Console)*.diff --git a/docs/usage.md b/docs/usage.mdindex bcdb1c3..e5adedb 100644--- a/docs/usage.md+++ b/docs/usage.md@@ -143,8 +143,6 @@ If using brushless motors and ESCs:1. Set the appropriate PWM using the parameters: `MOT_PWM_STOP`, `MOT_PWM_MIN`, and `MOT_PWM_MAX` (1000, 1000, and 2000 is typical).2. Decrease the PWM frequency using the `MOT_PWM_FREQ` parameter (400 is typical).-Reboot the drone to apply the changes.-> [!CAUTION]> **Remove the props when configuring the motors!** If improperly configured, you may not be able to stop them.