Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Make some clarifications regarding imu check in troubleshooting
Oleg Kalacheve3c6a0d4df64
diff --git a/docs/troubleshooting.md b/docs/troubleshooting.mdindex 2df0d6b..fb1b466 100644--- a/docs/troubleshooting.md+++ b/docs/troubleshooting.md@@ -17,8 +17,10 @@ Do the following:* **Check if the CLI is working**. Perform `help` command in Serial Monitor. You should see the list of available commands.* **Configure QGroundControl correctly before connecting to the drone** if you use it to control the drone. Go to the settings and enable *Virtual Joystick*. *Auto-Center Throttle* setting **should be disabled**.* **Make sure you're not moving the drone several seconds after the power on**. The drone calibrates its gyroscope on the start so it should stay still for a while.-* **Check the IMU sample rate**. Perform `imu` command. The `rate` field should be about 1000 (Hz).-* **Check the IMU data**. Perform `imu` command, check raw accelerometer and gyro output. The output should change as you move the drone.+* **Check the IMU is working**. Perform `imu` command and check its output:+ * The `status` field should be `OK`.+ * The `rate` field should be about 1000 (Hz).+ * The `accel` and `gyro` fields should change as you move the drone.* **Calibrate the accelerometer.** if is wasn't done before. Type `ca` command in Serial Monitor and follow the instructions.* **Check the attitude estimation**. Connect to the drone using QGroundControl. Rotate the drone in different orientations and check if the attitude estimation shown in QGroundControl is correct.* **Check the IMU orientation is set correctly**. If the attitude estimation is rotated, make sure `rotateIMU` function is defined correctly in `imu.ino` file.