Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Include FlixPeriph header instead of MPU9250 This simplifies choosing IMU model
Oleg Kalacheve673b50f52d1
diff --git a/README.md b/README.mdindex ba83593..a1d79fe 100644--- a/README.md+++ b/README.md@@ -87,7 +87,7 @@ The simulator is implemented using Gazebo and runs the original Arduino code:|Tape, double-sided tape||||*² — barometer is not used for now.*<br>-*³ — change `MPU9250` to `ICM20948` in `imu.ino` file if using ICM-20948 board.*<br>+*³ — change `MPU9250` to `ICM20948` or `MPU6050` in `imu.ino` file for using the appropriate boards.*<br>*³⁻¹ — MPU-6050 supports I²C interface only (not recommended). To use it change IMU declaration to `MPU6050 IMU(Wire)`.*<br>*⁴ — this frame is optimized for GY-91 board, if using other, the board mount holes positions should be modified.*<br>*⁵ — you also may use any transmitter-receiver pair with SBUS interface.*diff --git a/docs/troubleshooting.md b/docs/troubleshooting.mdindex cc6d4c1..7e48c93 100644--- a/docs/troubleshooting.md+++ b/docs/troubleshooting.md@@ -15,7 +15,7 @@ Do the following:* **Check the battery voltage**. Use a multimeter to measure the battery voltage. It should be in range of 3.7-4.2 V.* **Check if there are some startup errors**. Connect the ESP32 to the computer and check the Serial Monitor output. Use the Reset button to make sure you see the whole ESP32 output.* **Check the baudrate is correct**. If you see garbage characters in the Serial Monitor, make sure the baudrate is set to 115200.-* **Make sure correct IMU model is chosen**. If using ICM-20948 board, change `MPU9250` to `ICM20948` everywhere in the `imu.ino` file.+* **Make sure correct IMU model is chosen**. If using ICM-20948/MPU-6050 board, change `MPU9250` to `ICM20948`/`MPU6050` in the `imu.ino` file.* **Check if the CLI is working**. Perform `help` command in Serial Monitor. You should see the list of available commands. You can also access the CLI using QGroundControl (*Vehicle Setup* ⇒ *Analyze Tools* ⇒ *MAVLink Console*).* **Configure QGroundControl correctly before connecting to the drone** if you use it to control the drone. Go to the settings and enable *Virtual Joystick*. *Auto-Center Throttle* setting **should be disabled**.* **If QGroundControl doesn't connect**, you might need to disable the firewall and/or VPN on your computer.diff --git a/flix/imu.ino b/flix/imu.inoindex cf29c8e..0934ada 100644--- a/flix/imu.ino+++ b/flix/imu.ino@@ -4,7 +4,7 @@// Work with the IMU sensor#include <SPI.h>-#include <MPU9250.h>+#include <FlixPeriph.h>#include "lpf.h"#include "util.h"