Free Motion Capture for Everyone πβ¨
TypeScript
Multiple typo/spelling/grammar fixes.
follower04b64fb486dd
diff --git a/README.md b/README.mdindex 29f8b23b..0720337b 100644--- a/README.md+++ b/README.md@@ -15,8 +15,8 @@ ___* Two or more USB webcams attached to viable USB ports* USB hubs typically don't work- * Note that two cameras is the minimum reuired for 3d reconstruction. GHowever, with just two views, many points will be occluded/not visible to both cameras. For better performance, use three or four cameras-* Each recording must (for now) an unobstructed view of a Charuco board within the first few seconds of recording (See below).+ * Note that two cameras is the minimum required for 3d reconstruction. However, with just two views, many points will be occluded/not visible to both cameras. For better performance, use three or four cameras+* Each recording must (for now) have an unobstructed view of a Charuco board within the first few seconds of recording (See below).________# Installation@@ -145,7 +145,7 @@ ________## `fmc.RunMe()` Specify recording session paramters___-The `fmc.RunMe()` function takes a number of parameters that can be used to alter it's default behavior in important ways. Here are the default parameters along with a followed by a brief description of each one.+The `fmc.RunMe()` function takes a number of parameters that can be used to alter its default behavior in important ways. Here are the default parameters followed by a brief description of each one.### RunMe - Default parameters@@ -178,13 +178,13 @@ def RunMe(sessionID=None,- Type - (str)- [Default] - None.- Indentifying string to use for this session.- - If creating a new session, default behavior is to autogerate SessionID is based on date and time that the session was recorded+ - If creating a new session, default behavior is to autogenerate SessionID based on date and time that the session was recorded- If re-processing a previously recorded session, this value specifies which session to reprocess (must be the name of a folder within the `FreeMoCap_Data` folder)-- `stage`- [Type] - Int- [Default] - 1- - Which processing stage to start from. Processing stages are deined in more detail in [#processing-stages](#processing-stages)+ - Which processing stage to start from. Processing stages are defined in more detail in [#processing-stages](#processing-stages)```stage 1 - Record Raw Videos@@ -280,7 +280,7 @@ ___* IMPORTANT The Charuco board shown to the camera MUST be generated with the `cv2.aruco.DICT_4X4_250` dictionary!- * Ah high resoultion `png` of this Charuco board is in this repository at `/charuco_board_image_highRes.png`+ * A high resolution `png` of this Charuco board is in this repository at `/charuco_board_image_highRes.png`** To generate your own board, use the following python commands (or equivalent). DO NOT CHANGE THE PARAMETERS OR THE CALIBRATION WILL NOT WORK:``` python