Skip to content

A truly modular keyboard

C

done with v1, on to v2!

Nathan971b6860f6a4
diff --git a/JOURNAL.md b/JOURNAL.md
index 39c7bc7..322a1fb 100644
--- a/JOURNAL.md
+++ b/JOURNAL.md
@@ -2,7 +2,17 @@
This journal is auto generated by Stasis.
-->
-# 11/1/2026 1 PM - Tough 2000 Cases
+# 11/01/2026 11:00 PM - Thoughts on the first revision and prep for V2
+
+_Time spent: 1h_
+
+Okay so this is fine and all but taking a look at the state of the project, I think that I shouldn't waste too much time fleshing out this first version anymore as I know how to improve it and have tested everything there is to test (well maybe except battery charging but I'll do that rn). I want to make this significantly cheaper so that others can actually use this, one of those ways would be to use CH592F and make a 1u controller board instead of a 2 stacked 1u boards as that caused a lot of inneficiencies with the case and also the corners are kind of cooked (this also means I can have a bigger battery on the top) and following the designs for the ones on the bottom, this should all fit inside a caserather nicely. I also plan on making versions that have rotary encoders, oleds, and yea. Some other stuff that I found would be to make everything from a flex pcb as this would make things significantly easier to put together in a case.. I am also thinking about steering away from pogo pins and just using magnets with conductive epoxy for the connections as this would save a TON of money and yea. I think that this is feasable and i was looking at displays and found this https://www.buydisplay.com/square-white-0-96-inch-96x96-oled-display-screen-ssd1317. I'll start cadding a new version tmrw but oh well this is good for a V1.
+
+https://www.amazon.com/HARFINGTON-Stainless-Cylindrical-Furniture-Installation/dp/B0F6D1P67B
+
+
+
+# 11/1/2026 1 PM - Tough 2000 Cases (Final V1 Journal)
_Time spent: 5h_