Skip to content

armgit / moss

Public Imported from GitHub
0

MOSS: a small, mostly 3D-printed litter-picking rover. Cleaner streets, one maker at a time.

Python
2.1 KB
Raw Blame

Measured fastening lengths

Dimensions were checked against the current R92 printable STEP and the component references. Quantities are for one rover; Jetson and Pi are alternatives.

Joint Prepare Measurement
Motor to printed bracket 6 × M3 × 8 socket-head screws; no washers 5 mm bracket + 3 mm into the motor. The reference motor has a 4 mm deep hole.
Jetson retaining tabs 2 × M3 × 8 socket-head screws; no washers 2.4 mm tab + 5.6 mm into the printed pilot. The shorter current pilot is 6.5 mm deep.
Pi / HAT Use the screws and spacers supplied with the HAT The carrier passage is 9.3 mm; with the 1.6 mm PCB the lower stack is 10.9 mm. The reference spacers are 16 mm tall.
Wrist camera PCB, R30 mount 4 × M2 × 6 non-countersunk screws 1.6 mm PCB + 4.4 mm in the Ø1.7 mm printed pilots.
Wrist-camera bracket to gripper 2 × M3 × 10 socket-head screws + 2 × M3 hex nuts; no washers 5.5 mm through the printed bracket. The existing assembly check leaves 0.75 mm between screw tip and servo.
LiDAR carriage lock 1 × M3 × 20 socket-head screw; no washer 15 mm carriage + 0.2 mm insert recess + 4.8 mm thread engagement; 1.2 mm remains before the rear of the 6 mm insert.

The wrist-camera measurements apply to the R30 mount with its 21 × 13.5 mm PCB hole pattern. Use the camera that matches this mount.

Pi / HAT hardware

Use the HAT's supplied mounting hardware. No separate HAT screw purchase is added. The measured carrier thickness does not establish the length of the screws in the received kit. Raspberry Pi describes the supplied spacers and upper/lower screw sets in its AI HAT assembly instructions.

Jetson retaining tabs

Print one JT01 and one JT02 in PETG. Download the first tab and second tab separately from the unchanged original archive. Both tabs are 2.4 mm thick and use the two screws listed above.