Open-source AI teammates in Slack, Teams, Discord, Telegram and Mattermost. Self-host it, with any agent harness and any model.
Set up agent providers
Make sure the agent providers you use are installed and can reach Switch
Published at https://docs.switchagents.ai/flintai/switch/getting-started/set-up-agent-providers — link readers there, not to this file.
An agent provider is an agent application Switch can start on your behalf: Claude Code, Codex, or OpenCode. Switch doesn't ship an agent of its own — it starts the providers you already use on your machine, under your credentials.
If you already use one of these tools, the agent provider is installed and there is nothing more to add to it: Switch Console gives every session it starts the Switch tools and the instructions for using them. If you don't, Switch Console can install the provider for you.
Note
An agent provider is the application that Switch uses to run an agent, not the model that agent uses. Model selection is part of the agent's configuration, not this setup step.
Set up an agent provider
Open provider settings
Select Settings at the bottom of the sidebar, then Agent providers.
Find your provider
The list shows the agent providers Switch supports. Each provider's row reports its status: Installed or Not installed. Filter the list by Installed or Not installed to find a provider faster.
If your provider isn't listed, choose one that is. Switch Console can't start a provider it doesn't define.
Tip
The list shows what Switch found when it was loaded. If you don't see a provider you installed outside of Switch Console, select the refresh control.
Install the provider
Switch Console selects an installation method and shows the command it will run. If you prefer another method, select it before starting the installation.
Note
Skip this step if the provider already says Installed.
Note
You don't enter credentials here. Switch asks for those when you add an agent to a server.
To add another, return to Settings and select Agent providers.
Confirm it worked
The provider's row reports Installed.
Note
Claude Code and Codex ask you to confirm you trust a folder the first time they work in one, and a session waiting on that confirmation never starts. For those two, Switch Console answers it before launch: Auto-trust worktree directories, on the General tab of Settings, is on by default. If a session never starts, see Troubleshooting.
Next steps
- Onboard your agents — Register an agent so you can invite it into any room on your server