Making an ESP32-based quadcopter from scratch
Python arduinoautopilotcontrol-theorydroneesp32flight-controlflight-controllermavlinkquadcopterquadcopter-firmwareuav
Commits on master
Remove core installation when running the sim Split `dependencies` target to `core` and `libs` targets. Move additional urls declaration and connection timeout from arduino-cli.yaml to Makefile for simplicity and transparency. Update ESP32 core url. Remove arduino-cli.yaml.
8e2ffd7 Oleg Kalachev committed 5 months ago
Bring back espnow tx buffering keeping resends disabled Buffering is needed for sending large prints, otherwise the espnow internal buffer overflows. Make onSent always think there was success send, so there won't be any resends. Print lost espnow packets count on wifi console command.
52b74af Oleg Kalachev committed 5 months ago
Make each mavlink message rate configured separately Add parameters: * MAV_RATE_ATT - ATTITUDE_QUATERNION rate. * MAV_RATE_RC - RC_CHANNELS_RAW rate. * MAV_RATE_MOT - ACTUATOR_CONTROL_TARGET rate. * MAV_RATE_IMU - SCALED_IMU rate.
0ca2473 Oleg Kalachev committed 5 months ago
Make it possible to unassign motor pin using -1 parameter value
1fafc27 Oleg Kalachev committed 5 months ago
Replace ps and psq commands with st command + minor changes Re-arrange commands order. Make command parser consider \r in addition to \n.
faca48c Oleg Kalachev committed 5 months ago
Increase buffer for print, make sys output more correct usStackHighWaterMark is not stack size, it's the minimum stack size
59f9528 Oleg Kalachev committed 5 months ago
Add malagis custom pcb version of Flix project to builds
607b2ff Oleg Kalachev committed 5 months ago
Set the debug level to error by default to see the errors
488ceb3 Oleg Kalachev committed 5 months ago
Consider mavlink connected only when the gcs message is parsed
b83c9b3 Oleg Kalachev committed 5 months ago
Support ESP-NOW connection in pyflix Set arbitrary pymavlink connection string using device parameter or FLIX_DEVICE env variable. [email protected].
4e32414 Oleg Kalachev committed 5 months ago
Make p command show all parameters starting with the arg
a294883 Oleg Kalachev committed 5 months ago
Fix simulator run Add missing extern variables. Fix warning.
cdfba72 Oleg Kalachev committed 5 months ago
Improve voltage measurement Apply PWM_VOLT_PIN without reboot. Check if the voltage pin can be used with ADC when setting up. Set voltage to NAN, when it's unknown (including pyflix). [email protected]. Don't send BATTERY_STATUS when voltage is unknown. Add dummy voltage to the simulator.
bd2b1bd Oleg Kalachev committed 6 months ago
Bring back initializing the lpf with the first input value It's much better for voltage measuring and slightly better for gyro bias estimation.
3816ae3 Oleg Kalachev committed 6 months ago